Korena
Product detailSKU #1294516231293

dbx215s Dual-Channel 15-Band Graphic Equalizer

dbx
dbx 215s Dual-Channel 15-Band Graphic Equalizer
1/8

Independent shopping perspective

The Korena take

Two channels of 15-band graphic EQ in one rack space. For tuning a small PA, monitor sends, or a fixed install on a budget.

dbx 215s Dual-Channel 15-Band Graphic Equalizer product detail
Product studydbx 215s Dual-Channel 15-Band Graphic Equalizer
dbx 215s Dual-Channel 15-Band Graphic Equalizer alternate view
Alternate view

Strong match

Who this is for

  • Ringing out two wedge mixes from one rack space
  • Small PA left/right tone shaping in a portable rack
  • Fixed installs where nobody should touch fine detail

Consider the trade-offs

When to look elsewhere

  • Narrow feedback notching — sliders are too wide apart
  • Anyone needing surgical room correction; step up to 31 bands
  • Racks already tight on depth or with no rear access

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

dbx 215s Dual-Channel 15-Band Graphic Equalizer construction detail

Detail 01

15 bands per channel

Fifteen sliders cover the full 20Hz–20kHz span, so each one moves a wide chunk of the spectrum at once.

Detail 02

±6dB / ±12dB range switch

Set ±6dB for everyday tone work and you get finer slider resolution; ±12dB is there when a room really fights you.

Detail 03

50Hz 12dB/octave low cut

Kills stage rumble and handling thump without spending sliders on it, so the low band stays free for tone.

Detail 04

1.75 inch H, 19 inch W

One rack space for two channels. Half the rack height of the 231s for the same channel count.

Detail 05

>+21dBu max input and output

Plenty of headroom for hot console outputs; it will not clip before your amp does.

Detail 06

100–240VAC, IEC connection

Runs anywhere in the world off a standard cable. No voltage switch to get wrong on a touring rack.

Final check

Know before you order

  1. 01Needs a full rack space plus roughly 6 inches of clearance behind the panel
  2. 02Insert or output patching only — this is not a mixer channel strip
  3. 03Check whether your gear is XLR or 1/4 inch TRS before ordering cables
dbx 215s Dual-Channel 15-Band Graphic Equalizer close-up

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01Can I run two separate monitor mixes through it?

Yes. The two channels are independent, so one can handle a wedge mix and the other a second wedge or a main output.

02Is 15 bands enough to ring out a room?

For broad problem areas, yes. For pinpoint feedback frequencies the sliders are spaced too far apart — a 31-band gets closer to the exact spot.

03Does it work with unbalanced gear?

Yes. The inputs and outputs are impedance-balanced and accept unbalanced connections, with the same headroom either way.

04What is the EQ bypass button for?

It takes the graphic section out of the signal path so you can A/B your settings against flat, or leave signal passing if you want the EQ out.

Reference

Full specifications

The complete catalog record, organized around the decisions musicians make when comparing gear.

5 detailsOther
Category Source
detail
Tier
new
Korena Special
false
Source Id
site51294516231293
Prop65
WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov.