Detail 01
Up to 12 monitor outputs
Supports custom speaker configurations with as many as 12 output channels.
Product detailSKU #1500000338172
FocusriteRedNet R1 Remote Controller for Red Interfaces With PoE
1/8
Independent shopping perspective
The Korena take
RedNet R1 is a hands-on monitor-control and routing remote for Focusrite Red interfaces. It can manage monitor layouts from mono to 7.1.4, including immersive workflows, or a custom configuration of up to 12 outputs. From the surface, you can handle level, cut, dim, mute, solo, A/B monitoring and fold-down checks, then route cue mixes and talkback where they are needed. RedNet Control2 handles configuration for both straightforward and more involved monitoring systems.
Strong match
Who this is for
- Studios moving between mono, surround, 7.1.4, or custom monitor configurations.
- Control rooms needing fast A/B, fold-down, cut, dim, mute, and solo monitoring checks.
- Sessions that need custom cue mixes and talkback routing from available input channels.
Consider the trade-offs
When to look elsewhere
- Monitoring systems requiring more than 12 monitor output channels.
- Workflows that need more than eight simultaneously selectable input sources.
- Non-Red Dante-device setups requiring more than one talkback destination group.
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Eight sources from 32 available channels
Allows selection and routing of up to eight input sources across the available channels.
Detail 03
Up to four fold-down presets
Enables quick switching when checking downmixes.
Detail 04
PoE or supplied 12V DC power
Can be powered over Ethernet or from the supplied locking-barrel DC supply.
Detail 05
32–600 ohm headphone impedance
The headphone output is specified for headphones within that impedance range.
Final check
Know before you order
- 01Configure monitoring and routing through RedNet Control2.
- 02For up to four talkback destination groups, use RedNet R1 with a Red interface; other Dante devices support one group.
- 03Confirm your network power meets IEEE 802.3af PoE requirements if powering the unit over Ethernet.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How many monitor outputs can RedNet R1 control?
It can mix and route to up to 12 monitor output channels, including custom configurations of up to 12 outputs.
02Can it control immersive monitoring?
Yes. It supports monitor configurations through 7.1.4, including Dolby Atmos and other immersive workflows.
03How is RedNet R1 powered?
It can run from IEEE 802.3af Power over Ethernet or the supplied 12V DC power supply.
04Does it have talkback facilities?
Yes. It has Dante-enabled talkback, an internal microphone, an external XLR talkback input, and a footswitch jack for talkback management.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
5 detailsOther
- Category Source
- detail
- Tier
- new
- Korena Special
- false
- Source Id
- site51500000338172
- Prop65
- WARNING: This product can expose you to chemicals including Lead, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov
Complete your setup
Worth comparing
1 of 12
More from Focusrite
1 of 8
