Korena
Product detailSKU #1273888005044

FurmanP-2400 AR Voltage Regulator/Power Conditioner

Furman
Furman P-2400 AR Voltage Regulator/Power Conditioner
1/8

Independent shopping perspective

The Korena take

39 lb rackmount voltage regulator with 14 outlets. For rigs on unstable AC that need the line held near 120V, not just filtered.

Furman P-2400 AR Voltage Regulator/Power Conditioner product detail
Product studyFurman P-2400 AR Voltage Regulator/Power Conditioner
Furman P-2400 AR Voltage Regulator/Power Conditioner alternate view
Alternate view

Strong match

Who this is for

  • Venues and rentals where line voltage sags under load
  • Large racks needing 14 protected 20A outlets
  • Installs where gear runs unattended on questionable power

Consider the trade-offs

When to look elsewhere

  • Small pedalboard or single-amp setups
  • Anyone on stable house power who only needs surge protection
  • Shallow racks — it runs 12 inches deep and weighs 39 lb

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Furman P-2400 AR Voltage Regulator/Power Conditioner construction detail

Detail 01

Regulation from 97 to 137 VAC

Input inside that window gets corrected toward nominal, so amps and supplies see steady voltage as the room load shifts.

Detail 02

Fourteen 20A outlets, twelve rear and two front

Enough for a full touring rack with two front sockets left for a lamp or test gear.

Detail 03

20 amp maximum current

Derates 170mA per volt below 120VAC, so a sagging line reduces how much you can actually pull.

Detail 04

39 pounds

Heavy enough that it needs rear rack support, not just front ears, in anything that gets moved.

Detail 05

Over-voltage shutdown at 145 VAC

Beyond the regulation window it disconnects rather than passing a damaging line through to your gear.

Detail 06

3.5 inch H, 19 inch W, 12 inch D

Two rack spaces plus depth for the transformer — check clearance behind the rails.

Final check

Know before you order

  1. 01Needs a 20A circuit and NEMA 20 receptacle; the cord is captive
  2. 02Rear rack rails or a support shelf are strongly advised at 39 lb
  3. 03Regulation transformers can hum audibly — keep it away from live mics
Furman P-2400 AR Voltage Regulator/Power Conditioner close-up

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01How is this different from a plain power conditioner?

It actively corrects input voltage between 97 and 137 VAC back toward nominal. A conditioner only filters noise and clamps spikes, passing low voltage straight through.

02How many outlets does it have?

Fourteen total 20A NEMA5-20R: twelve on the rear panel and two on the front.

03Will it run my whole rack?

Up to 20 amps at 120VAC. Below 120VAC input, capacity drops 170mA per volt, so budget headroom on weak circuits.

04How much rack space does it take?

Two spaces at 3.5 inches tall, 12 inches deep, 39 pounds. Plan on rear support.

Reference

Full specifications

The complete catalog record, organized around the decisions musicians make when comparing gear.

4 detailsOther
Category Source
detail
Tier
new
Korena Special
false
Source Id
site51273888005044

Worth comparing

More from Furman