Detail 01
1 in. size
Sized for one specific tube diameter. Measure your stand's tube before ordering; a lock that does not clamp is useless.
Product detailSKU #1273887993033
Gibraltar4-Pack Memory Locks 1 in.
1/8
Independent shopping perspective
The Korena take
Four 1 in. memory locks for drum hardware tubes. For players who tear down and reset a kit and want the same heights back.
Strong match
Who this is for
- Gigging drummers who break down and rebuild a kit nightly
- Marking cymbal and tom heights before a load-out
- Stopping heavy toms from creeping down mid-set
Consider the trade-offs
When to look elsewhere
- Kits whose tubes are not 1 in. diameter
- Drummers who leave one kit permanently set up
- Anyone needing locks for smaller upper stand sections
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
4-pack
Covers roughly one cymbal stand pair or a couple of tom mounts. A full kit usually needs more than one pack.
Detail 03
Memory lock function
Clamps below a height adjustment so the tube always drops to the same spot. Also stops slow slippage under weight.
Detail 04
Metal clamp design
Bites the tube directly. Overtightening on thin or chrome tubing can mar the finish over time.
Final check
Know before you order
- 01Measure tube diameter with calipers — stand sections step down in size
- 02Set your kit up fully before locking positions in
- 03Locks are consumable hardware; wing bolts can strip if forced
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will these fit any drum stand?
Only tubes that measure 1 in. Most stands use several diameters across their sections, so one size will not fit the whole stand.
02How many do I need for a full kit?
Count every height joint you want to repeat — cymbal stands, tom arms, snare stand. Four covers a small part of a typical kit.
03Do memory locks stop toms from sinking?
Yes. Set below the adjustment point, the lock takes the weight instead of the clamp friction alone.
04Are tools needed to install them?
They tighten with the built-in bolt. A drum key or hex wrench may help get them fully snug.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
4 detailsOther
- Category Source
- detail
- Tier
- new
- Korena Special
- false
- Source Id
- site51273887993033
Worth comparing
1 of 12
More from Gibraltar
1 of 8
