Detail 01
Detachable leg base that screws into the peg
Breaks into two pieces small enough to store inside the bell, so nothing extra rides in your bag.
Product detailSKU #1274115037532
K&M15290 Straight Soprano Saxophone Stand
1/8
Independent shopping perspective
The Korena take
A compact peg-style stand for straight soprano sax. Fits players who want a stand that stores inside the horn's bell.
Strong match
Who this is for
- Gigging soprano players who pack light between sets
- Doubling on stage and needing the horn parked upright
- Practice rooms where floor space is tight
Consider the trade-offs
When to look elsewhere
- Curved soprano saxes — this holds a straight body
- Alto, tenor or baritone horns
- Players wanting a stand for multiple horns at once
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Rubber-covered peg top
The contact point against the inside of the bore won't scratch lacquer or mark the bell throat.
Detail 03
Zinc die-cast legs
Metal legs give the base weight low to the ground, so the horn is less likely to tip from a bump.
Detail 04
Felt pads on the peg
Cushions the horn where it rests, protecting the interior finish over repeated setups.
Detail 05
9.84 in / 250 mm height
Sits low. The horn's bell sits near the floor, so it stays clear of mic stands and cables.
Detail 06
0.73 lb weight
Light enough to forget about in a gig bag, but relies on the wide leg base rather than mass for stability.
Final check
Know before you order
- 01Peg style — the horn rests bell-down over the post, not in a cradle
- 02Legs unscrew for storage, so expect to assemble it at each gig
- 03Check your bell's inner diameter clears the rubber-topped peg
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will this hold a curved soprano sax?
No. It's built for a straight soprano. A curved soprano needs a stand shaped for its bell angle.
02Does it really fit inside the horn?
The leg base unscrews from the peg, and the parts are sized to be kept inside the instrument bell.
03Is it stable enough for a stage?
The zinc die-cast leg base gives it a low, weighted footprint. It's still a peg stand, so keep it clear of foot traffic.
04Will it scratch the lacquer?
The peg top is rubber-covered and the support uses felt pads at the contact points.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black/Grey
4 detailsOther
- Category Source
- detail
- Tier
- new
- Korena Special
- false
- Source Id
- site51274115037532
Worth comparing
1 of 12
