Korena
Product detailSKU #1292606661785

ProlineB500K Control Potentiometer

Proline
Proline B500K Control Potentiometer
1/8

Independent shopping perspective

The Korena take

A 500K audio-taper control pot for guitar wiring. For anyone repairing a scratchy volume or tone control, or building a passive circuit.

Proline B500K Control Potentiometer product detail
Product studyProline B500K Control Potentiometer
Proline B500K Control Potentiometer alternate view
Alternate view

Strong match

Who this is for

  • Replacing a crackling or dead volume pot on a guitar
  • Wiring a humbucker guitar where 500K keeps highs open
  • Stocking a repair bench with a common-value spare

Consider the trade-offs

When to look elsewhere

  • Players unwilling to solder or pay a tech
  • Single-coil guitars voiced around 250K pots
  • Active pickup systems, which use much lower values

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Proline B500K Control Potentiometer construction detail

Detail 01

500K resistance

Higher resistance bleeds less treble to ground. Standard for humbuckers; single-coils on 500K get brighter, sometimes harsh.

Detail 02

B taper

Linear taper. Volume changes evenly across the sweep instead of staying loud until the last quarter turn.

Detail 03

Potentiometer, not a switch

Works as either a volume or tone control depending on how you wire it into the circuit.

Detail 04

Shaft and bushing sizing

Pot bodies vary in shaft diameter, thread length and knob fit. Measure your existing pot before ordering.

Final check

Know before you order

  1. 01No knob included. Reuse your old one or buy separately.
  2. 02Soldering iron and basic wiring skill required; a tech charges for install.
  3. 03Check your control cavity depth and top thickness for shaft length.
Proline B500K Control Potentiometer close-up

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01Is 500K right for my guitar?

500K is the usual choice for humbuckers, keeping treble intact. Guitars built around single-coils typically use 250K and will sound brighter if you swap to 500K.

02What does the B mean?

B indicates a linear taper, where resistance changes evenly through the rotation. A audio taper is more common for volume; linear is often preferred for tone controls.

03Can I use this for volume or tone?

Both. The same pot works either way, depending on wiring. Only the taper feel changes with the job.

04Does it come with a knob?

No. This is the pot only. Your existing knob may fit depending on shaft type, so check split-shaft versus solid-shaft before assuming.

Reference

Full specifications

The complete catalog record, organized around the decisions musicians make when comparing gear.

5 detailsOther
Category Source
detail
Tier
new
Korena Special
false
Source Id
site51292606661785
Prop65
WARNING: This product can expose you to chemicals including Lead, which is known to the State of California to cause cancer, and Cadmium, which is known to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.