Korena
Product detailSKU #1300744185156

ShureBETA 52A Kick Mic With Cable and Stand

Shure logo
Shure BETA 52A Kick Mic With Cable and Stand
1/8

Independent shopping perspective

The Korena take

Dynamic kick drum mic with a built-in swiveling stand mount, sold with cable and a stand. For drummers and engineers miking a bass drum.

Shure BETA 52A Kick Mic With Cable and Stand product detail
Product studyShure BETA 52A Kick Mic With Cable and Stand
Shure BETA 52A Kick Mic With Cable and Stand alternate view
Alternate view

Strong match

Who this is for

  • Miking a kick drum inside the shell or at the port
  • Gigging drummers who need one reliable low-end mic
  • Bass cabinets and floor toms that need weight, not air

Consider the trade-offs

When to look elsewhere

  • Vocals, cymbals or acoustic guitar — response stops at 10kHz
  • Anyone needing a flat, uncolored capture for classical work
  • Players who already own a stand and cable and want mic only

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Shure BETA 52A Kick Mic With Cable and Stand construction detail

Detail 01

Supercardioid pattern

Tight front pickup with rejection at the sides, so hi-hat and toms bleed in less than with a cardioid.

Detail 02

20Hz to 10kHz response

Deep sub extension, no top end above 10k. It captures thump and beater click, not cymbal shimmer.

Detail 03

174dB max SPL

It will not distort inside a kick drum, no matter how hard the beater hits.

Detail 04

Dynamic moving coil

No phantom power needed, and it shrugs off the air blast and humidity inside a drum shell.

Detail 05

Integral locking stand adapter, 180 degrees

The mount is part of the body, so you aim it without a separate clip that can slip mid-set.

Detail 06

605g die-cast metal body

Heavy enough to stay put, but load it on a sturdy boom — a light stand will nose over.

Final check

Know before you order

  1. 01Needs a 5/8-27 thread stand; European 3/8 stands require a thread adapter
  2. 02No phantom power required, but you will want preamp gain
  3. 03Position inside the drum changes tone more than any EQ move here
Shure BETA 52A Kick Mic With Cable and Stand close-up

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01Does the BETA 52A need phantom power?

No. It is a dynamic moving coil mic and works from any standard XLR mic input. Phantom power will not harm it if your console sends it globally.

02Can I use it on bass guitar cabinets?

Yes. The low-end extension and high SPL handling suit bass cabs and floor toms as well as kick drums.

03Does it come with a stand?

Yes. This listing includes a cable and a stand along with the mic and its built-in locking stand adapter.

04Where do I place it in the kick drum?

Inside the shell aimed at the beater gives click and attack. Pulled back toward the port or just outside gives more body and less snap.

Reference

Full specifications

The complete catalog record, organized around the decisions musicians make when comparing gear.

5 detailsOther
Category Source
detail
Tier
new
Korena Special
false
Source Id
site51300744185156
Prop65
WARNING: This product can expose you to chemicals including Diisononyl phthalate (DINP), which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov

Complete your setup

Worth comparing

More from Shure