Korena
Product detailSKU #1274115062911

Universal AudioUA-S610 SOLO/610 Classic Vacuum Tube Microphone Preamp and D.I. Box

Universal Audio logo
Universal Audio UA-S610 SOLO/610 Classic Vacuum Tube Microphone Preamp and D.I. Box
1/8

Independent shopping perspective

The Korena take

Single-channel tube mic preamp and DI built on the 610 circuit. For someone recording one source at a time who wants tube coloration on the way in.

Universal Audio UA-S610 SOLO/610 Classic Vacuum Tube Microphone Preamp and D.I. Box product detail
Product studyUniversal Audio UA-S610 SOLO/610 Classic Vacuum Tube Microphone Preamp and D.I. Box
Universal Audio UA-S610 SOLO/610 Classic Vacuum Tube Microphone Preamp and D.I. Box alternate view
Alternate view

Strong match

Who this is for

  • Home studios tracking vocals or bass one source at a time
  • Adding tube warmth in front of a clean interface preamp
  • DI'ing bass or synths straight to the recorder

Consider the trade-offs

When to look elsewhere

  • Anyone needing two channels or built-in compression
  • Engineers who want transparent, uncolored gain
  • Tracking drums or anything needing multiple simultaneous inputs

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Universal Audio UA-S610 SOLO/610 Classic Vacuum Tube Microphone Preamp and D.I. Box construction detail

Detail 01

61dB maximum gain

Plenty for condensers and most dynamics. Very quiet ribbons on distant sources may run out of headroom.

Detail 02

Selectable 500 ohm or 2k ohm mic input impedance

Changes how the mic loads. Lower setting usually darkens and thickens; higher opens up the top end.

Detail 03

12AX7 and 6072 tube pair

Two gain stages you can retube later. Tube choice shifts the character more than any knob here.

Detail 04

Selectable 2.2M ohm or 47k ohm Hi-Z input

The 2.2M setting preserves passive pickup top end. 47k loads it down for a rounder bass tone.

Detail 05

20Hz to 20kHz +/-1dB

Flat across the audible band, so the color comes from the tube stage rather than a shaped frequency curve.

Final check

Know before you order

  1. 01One channel only. Stereo pairs or two-mic setups need a second unit.
  2. 02No compressor or EQ. Dynamics control happens elsewhere in your chain.
  3. 03Tubes drift over years and are a consumable replacement cost.
Universal Audio UA-S610 SOLO/610 Classic Vacuum Tube Microphone Preamp and D.I. Box close-up

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01Can I plug my bass directly into it?

Yes. The front panel 1/4 inch jack is a Hi-Z instrument input with selectable 2.2M ohm or 47k ohm loading, so passive basses and synths both work.

02Does it have phantom power for condenser mics?

It is a mic preamp with a 61dB gain range and selectable mic impedance. Confirm the phantom power switch on the unit before pairing it with a condenser.

03Will this replace my audio interface?

No. It feeds a line-level signal into your interface or converter. You still need something to get audio into the computer.

04How is this different from the 6176?

The 6176 pairs the same style of 610 preamp with an 1176 compressor in one box. This is preamp and DI only.

Reference

Full specifications

The complete catalog record, organized around the decisions musicians make when comparing gear.

4 detailsOther
Category Source
detail
Tier
new
Korena Special
false
Source Id
site51274115062911

Worth comparing

More from Universal Audio