Detail 01
110-ohm impedance
Matches what DMX controllers expect, so data stays clean across a daisy chain instead of glitching at the end.
Product detailSKU #1273887986327
ACCU CABLE3-Pin DMX Lighting Cable 10 ft.
1/8
Independent shopping perspective
The Korena take
A 10 ft, 3-pin DMX data cable built to the 110-ohm data standard. For linking lighting fixtures in a truss or floor run.
Strong match
Who this is for
- Short fixture-to-fixture hops in a truss or bar
- Mobile DJs replacing failing mic cables in a light chain
- Cold outdoor gigs and hot fixture bodies
Consider the trade-offs
When to look elsewhere
- Fixtures with 5-pin DMX input, without an adapter
- Long booth-to-stage runs — 10 ft only
- Carrying power to a fixture; this is data only
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Foil tape plus 85% tinned copper braid shield
Two shield layers instead of one, which matters when the cable runs alongside dimmer and power lines.
Detail 03
22 AWG, two conductors
Thin and flexible enough to dress around truss clamps; it moves data, never fixture power.
Detail 04
3.2 inch minimum bend radius
Don't wrap it tight around your hand or zip-tie it into a hard corner. Kinks degrade the signal.
Detail 05
-30 C to +75 C range
Survives freezing outdoor nights and sitting against a hot fixture housing between sets.
Detail 06
0.229 inch outer diameter
Chunky for its gauge because of the double shield. Coils take up more case space than mic cable.
Final check
Know before you order
- 01Ships as cable only — no adapters, no DMX terminator plug
- 02Check whether your fixtures use 3-pin or 5-pin XLR
- 0310 ft covers fixture spacing, not controller-to-first-fixture distance
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I just use a microphone cable instead?
It often works over short distances, but mic cable isn't built to the 110-ohm data spec. On longer chains you get flicker and stuck fixtures. This avoids that.
02Will this work with 5-pin DMX fixtures?
Not directly. The connectors are 3-pin XLR. You'd need a 3-to-5-pin adapter at the fixture end.
03Can I use this as a speaker or audio cable?
No. It's 22 AWG data cable with a 2.1 amp per conductor limit — nowhere near enough for speaker power.
04Do I need a terminator with this?
The cable doesn't include one. Terminators go on the last fixture in the chain and are sold separately.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
5 detailsOther
- Category Source
- detail
- Tier
- new
- Korena Special
- false
- Source Id
- site51273887986327
- Prop65
- WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer, and to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Worth comparing
1 of 12
More from ACCU CABLE
1 of 8
